Remove the turn signal lens. Slightly press the bulb and turn it 2. Support your motorcycle securely and their original locations on the wheel. Your dealer meets all road test your motorcycle after each periodic of these requirements. Attach the right and left side collars in 5. Tighten the upper lock nut. Turn the adjusting nuts 8.
Check the condition of the brake pad groove Always replace both left and right brake pads wear indicators. Concentration: 50% antifreeze and 50% distilled water. Turn the ignition switch off, stop the engine and wait for 2 to 3 minutes. Should be serviced by your dealer. Install and tighten the washers A and Washers B Nuts screws. Loosen the rear axle nut, lock nuts and turn the adjusting nuts so the rear wheel can be moved all the way forward for maximum drive chain slack. Press down on the centre pin to release the lock.
Battery produce explosive gas that can cause explosion. Remove the rear axle shaft, washer, Installation brake caliper bracket, rear wheel and 1. Thoroughly rinse your motorcycle with plenty ensure the long life of your Honda. Loosen the upper lock nut and turn the Lower adjusting nut upper clutch cable adjuster all the way in Lower lock nut to provide maximum freeplay. Remove the fuse box covers.
The minute digits start flashing. Goes off if the ignition key has the correct coding. A helmet set wire is in the tool kit. Remove the left side cover. Make sure no foreign objects enter the reserve tank opening. Remove the screw and collar.
. If the throttle does not move smoothly, close automatically, or if the cable is damaged, have the motorcycle inspected by your dealer. Loosen the axle pinch bolt and front axle Installation shaft. Height Windscreen You can adjust the windscreen height 2 Screws positions. Pull out the bulb without turning.
Hot coolant will scald you. Start button Hazard switch Switchable when the ignition switch is on. If the slack is not constant at all points, some links may be kinked and binding. If the index mark on the The drive chain slider need to be replaced if it washer enters the red zone on the label after is worn to the wear limit line. Always replace a blown fuse Wire connector with a spare of the same rating. Goes off when your speed reaches approximately Goes off when the engine starts.
Slowly lean the motorcycle to the left until its Parking weight rests on the side stand. In the interest of safety, take the motorcycle to be serviced only by your dealer. Turn the upper clutch cable adjuster until the freeplay is 10 to 20 mm 0. Doing so can make it unsafe. Make sure the installation order is the following illustration. Pull the fuses out with the fuse puller in. Install the brake caliper and tighten the 8.
Phillips screwdriver provided in the tool kit Hold the brakelight switch and turn the P. As long as these get downloaded they will stay active but if a link lays dormant for more than 30 days it will disappear, so just reply here and let me know if a certain link is not working and I will fix it. Tachometer red zone excessive engine rpm range Clock 12-hour display To set the clock: P25 Fuel gauge Remaining fuel when only 1st E segment starts flashing: approximately 2. Install the upper side caps. Turn the socket counterclockwise, and remove it.